BETAFPV LAVA 1104 7200KV Motor – Pavo20 Pro / Pro II, 3S

Bent a shaft in the carpet, or planted a motor into a tree? The BETAFPV LAVA Series 1104 7200KV Brushless Motor is the direct replacement for the 3S Pavo20 Pro and Pro II. It has plug-in leads, so swapping one takes minutes and you're back in the air.

These motors are built for 2.2" cinewhoops and deliver smooth torque for swift, controlled freestyle. With Gemfan D2.2 3-blade props, BETAFPV measured max thrust above 230g and a thrust-to-weight ratio over 5:1. Efficiency is up to 4.7g/W at low throttle and 1.9g/W under full load, which keeps flight times healthy while you're flying hard.

About "24mm": That's the length of the motor wires, not the motor size. The 24mm version has a plug-in connector made for the Pavo20 Pro and Pro II. The 7200KV motor is the 3S option (the 4S Pavo uses a 5500KV motor).

• KV: 7200KV (3S) | Weight: 5.3g
• Max power: 122.5W | Max current: 10.2A
• Shaft: Ø1.5mm, 5mm long
• Wires: 28AWG, 24mm, with connector
• Motor mount: 4× M2 on a Ø9mm pattern | Prop mount: 4× M2 on a Ø5mm pattern
• Recommended props: Gemfan D2.2 3-blade (1.5mm shaft)
• Recommended battery: LAVA II 3S 580mAh / 680mAh

Includes: 1× LAVA 1104 7200KV brushless motor, 4× M2×4 hex flat-head screws, 4× M2×5 hex flat-head screws. Sold individually. A full set needs four.

Common Questions

Which quads is this motor for?
It's made for the BETAFPV Pavo20 Pro and Pavo20 Pro II. The 7200KV version is for the 3S build, and the plug-in 24mm leads match the stock motor connectors.

What does "24mm" mean?
It's the length of the motor's wires. The 24mm version includes the plug-in connector for the Pavo20 Pro and Pro II. The 80mm version has long wires and no connector.

Is this for 3S or 4S?
3S. The 7200KV motor is the 3S option, while the 4S Pavo20 Pro II uses a lower-KV 5500KV motor. Don't mix KV values on one quad.

How many motors come in the pack?
One motor, with screws. You need four for a full set, and one or two spares is a smart idea if you fly indoors or in tight spaces.

What props should I use?
Gemfan D2.2 3-blade props with a 1.5mm shaft. On the Pavo20 Pro II the props are screw-fixed through the motor's 4× M2 mount, which keeps them from working loose.

What's in the box?
The motor plus four M2×4 and four M2×5 hex flat-head screws.